Update Klipper on Anet 8

I just wanted to update my klipper after a while not using the printer and run in the usual question: How do I do that again, so here is the way I did.

There is an explaination on the FAQ from klipper on github FAQ Klipper

First update the code

cd ~/klipper
git pull
~/klipper/scripts/install-octopi.sh

Rerun the makes

make menuconfig
make clean
make

Flash the firmware

sudo service klipper stop avrdude -v -p atmega1284p -c arduino -P /dev/ttyUSB0 -b 57600 -D -U flash:w:./out/klipper.elf.hex:i sudo service klipper start

Connect with octoprint and everything should be fine !

 

Update Klipper on Anet 8

Leave a Reply

Your email address will not be published. Required fields are marked *

Scroll to top